Bicycle Brakes Road Testing Machine
This tester is suitable to test bike’s run test & brake performance test; the design conforms to the test specs listed below. The tester is formed by two rollers with varied diameter and follows spec to install jump plates at bike’s seat tube, stepper, handle and load rack, with load set to this tester.
After adjusting the distance according to bike’s actual distance, constantly rotate the wheels by 7 ~ 24 km/hr and the bike is supposed to maintain its normal function, no part damage or crack is found; for brake test, follow the spec-specified roller’s friction coefficient, wind speed, ride-way slop and water-spray amount of loaded brake holding handle to test the performance and judge bike’s performance under the defined frequency. And we also can follow the international bike’s standards listed below to use the respective bike jig/fixture module:

* ISO
* BS / DIN / NF ( U.K. / Germany / France)
* CPSC / CSA ( Usa / Canada)
*J IS / JBMS / BA ( Japan )
* AS / NES ( Australia / New Zealand )
* GB / QB / CNS ( Mainland / Taiwan )